![]() Nor do we pass this data on to Google, we don not have them not at all! Nevertheless, this data of SOMEONE will provide us with valuable information about our site, we want You to like everything here, that You feel good and - of course - buy our products. We do not know who You are, whether You are male or female, how old You are, how Your weight is - no idea. But look at it: we do not even know who YOU are, we just see that SOMEONE looks at our pages, how he/she does that, how long this SOMEONE lingers on the respective pages, etc. That sounds dramatically to You, we know. Why do we have to do that? Quite simply, you have forbidden us to watch Your steps on our site with Google Analytics. Like I mentioned, I only took out the SD-ribbon assembly.Too bad, now we have to go back to the glass ball or read in the coffee grounds to understand our visitors. No battery, I’ll probably let it go for a low price in the future. Pulled it out for my Anafi, but this parts Anafi has a damaged board and camera housing is cracked.Ībout the only parts savagable are the motors, couple of legs, motor board, camera live feed harness and all Tilt/Stabilitizer ribbons, Vertical ribbon assembly and it’s minus the SD-ribbon assembly. I have a spare parts Anafi going to post on the classifies soon, everthing is there except the SD-ribbon assembly. Once replacing then all was well again, hope you get this going. I’m sorry to see this happen, Anafi is so sensitive I even damaged two ribbons. Everything else (camera feed harness/camera tilt/stabilitizer ribbons/SD-ribbon assembly/vertical ribbon assembly) are inchangable.įrom your pictures, couldn’t open the motor board picture to see if it’s damaged, but could see the tilt/stabilitizer ribbon is fried. ![]() ![]() The only part paired with the motherboard are the Camera. I’ve had success replacing a replacement motor board connected onto another motherboard, it works auctually still on my Anafi. Last option is just to say goodbye, sell it for spare parts and buy Mavic Air. ![]() I think sending the drone to official service in France (because in Poland there's no official service (sic!)) is not an option too, because it will cost me a pretty penny. the only thing coming to my mind is buying another gimbal from ebay, hoping that this time it isn't broken one. Now I don't really know how to deal with current situation - original set doesn't give live feed, so probably live feed cable is broken or rather pins of the cable or pin-out of motherboard got loosen. Unfortunately I must have bought broken one. I think that in case of buying working gimbal piece, swapping parts from your drone into it would sort out the issue. Pity because both gimbal and camera were working fine before all of those operations, but now only gimbal works properly. Gimbal calibrates correctly (without white casing, only bare camera), but the screen is blank as shown in the screenshot. Lastly I've tried to bring back initial state (my gimbal bracket with all the parts from my drone), but now I have new problem with live feed. Then I've tried swapping the live feed cable, ribbon cable and camera from the bought gimbal to my bent L bracket, but that haven't worked either - no gimbal movement, no feed from camera in this case.ģ. I've tried taking live feed cable, ribbons and camera from my gimbal and placing it to the L bracket of bought gimbal, but that haven't worked - no live feed, gimbal was working abnormally (very strange movements, no successful calibration), I believe it was broken piece unfortunatelly.Ģ.
0 Comments
Leave a Reply. |